I am having a problem with the isp driver seeing a StorageTek disk array LUNs. I am directly attaching to the array and everything works find as long as I plug into the A controller on the array. When I connect up to the B controller, I can not see any of the LUNs advertised. The QLogic firmware can see the LUNs. The only difference I can see are that the LUNs start at 0 on the A side and at 3 on the B side.
Kernel messages for the isp driver are: isp0: <Qlogic ISP 2312 PCI FC-AL Adapter> port 0xa000-0xa0ff mem 0xec060000-0xec060fff irq 17 at device 0.0 on pci1 isp0: Reserved 0x1000 bytes for rid 0x14 type 3 at 0xec060000 isp0: using Memory space register mapping isp0: [GIANT-LOCKED] isp0: Board Type 2312, Chip Revision 0x2, loaded F/W Revision 3.3.6 isp0: 839 max I/O commands supported isp0: NVRAM Port WWN 0x210000e08b1e4a71 isp0: bad execution throttle of 0- using 16 isp0: LIP Received isp0: Loop UP isp0: Port Database Changed isp0: LIP Received isp0: Port Database Changed isp0: Firmware State <Config Wait->Ready> isp0: 2Gb link speed/s isp0: Loop ID 0, Port ID 0xef, Loop State 0x2, Topology 'Private Loop' isp0: Target 0 (Loop 0x0) Port ID 0xef (role Initiator) Arrived isp0: Target 2 (Loop 0x2) Port ID 0xe4 (role Target) Arrived camcontrol devlist -v shows the following when connected to port A: scbus0 on isp0 bus 0: <STK BladeCtlr B210 0612> at scbus0 target 0 lun 0 (da0,pass0) <STK BladeCtlr B210 0612> at scbus0 target 0 lun 1 (da1,pass1) <STK BladeCtlr B210 0612> at scbus0 target 0 lun 2 (da2,pass2) < > at scbus0 target -1 lun -1 () scbus-1 on xpt0 bus 0: < > at scbus-1 target -1 lun -1 (xpt0) camcontrol devlist -v shows the following when connected to port B: scbus0 on isp0 bus 0: < > at scbus0 target -1 lun -1 () scbus-1 on xpt0 bus 0: < > at scbus-1 target -1 lun -1 (xpt0) Thanks, -- Dave _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
