Hi Matt,


   Thanks for your reply.  = The model of the Cisco router is 2811.  Do
   you think that lowering the= timeout to 5 seconds would be ok? I have
   seen that Cisco does not recommen= d a timeout below 30 seconds but
   after reading your reply and seeing as the= re are only a couple dozen
   hosts on this subnet I would think that thi= s would be fine.  Please
   confirm. Thanks again.



   
   Colin

   [EMAIL PROTECTED] .org wrote: -----

     To: freebsd-stable@freebsd.org
     From: Matt Douhan <[EMAIL PROTECTED] itsalad.org>
     Sent by: [EMAIL PROTECTED]
     Date: 09/19= /2005 01:54PM
     cc: Colin Farley <[EMAIL PROTECTED]>
     = Subject: Re: Gratuitous ARP
     On Monday 19 September 2005 19:31, Colin = Farley wrote:
     >    1.&nbs=p; Set the arp cache timeou= t of the cisco router
     very low so
     >    that outages a=re = minimal.  I would rather not do this as
     it will
     >    p= roblably stress th=e router too much.  Unfortunately I
     know little>    about cisco devices so=I really cant figure this
     one = out, does anyone
     >    think that this is a bad th=ing? &n= bsp;Can you tell a
     cisco device not to
     >    cache arp entri= es on just the=internal interface?  The
     subnet
     >    = currently consists of about 25 hosts =so this may not be
     so bad after
     = >    all?
     Depending on your Cisco router model you will= not have any issues
     whatsoever
     lowering the timeout to really low, in = the region of a few
     seconds.
     even an old 25xx device would be to han= dle that without problems.
     >
     >    2.  Ru= n an ANT task to =clear the cache on the cisco
     device, this
     >  = ;  task can become part of the UCARP=scripts.  This may be a
     go= od
     >    solution but security is a concern.
     This wou= ld be very very bad, cause no matter how you do it the
     security
     concern= would be severe.
     --
     Matt Douhan
     www.fruitsalad.org
     (remem= ber, amateurs built the Ark, professionals built the
     Titanic)
     ___     ______________________     5F__= ___________________
     freebsd-stable= @freebsd.org mailing list
     [1]http://lists.freebsd.org/mailman/li= stinfo/freebsd-stable
     To unsubscribe, send any mail to "freebsd-stab     [EMAIL PROTECTED]"

   
References

   1. 
3D"http://lists.freebsd.org/mailman/li_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to