On Monday 19 September 2005 19:31, Colin Farley wrote: > 1.&nbs=p; Set the arp cache timeout of the cisco router very low so > that outages a=re minimal. I would rather not do this as it will > problably stress th=e router too much. Unfortunately I know little > about cisco devices so=I really cant figure this one out, does anyone > think that this is a bad th=ing? Can you tell a cisco device not to > cache arp entries on just the=internal interface? The subnet > currently consists of about 25 hosts =so this may not be so bad after > all?
Depending on your Cisco router model you will not have any issues whatsoever lowering the timeout to really low, in the region of a few seconds. even an old 25xx device would be to handle that without problems. > > 2. Run an ANT task to =clear the cache on the cisco device, this > task can become part of the UCARP=scripts. This may be a good > solution but security is a concern. This would be very very bad, cause no matter how you do it the security concern would be severe. -- Matt Douhan www.fruitsalad.org (remember, amateurs built the Ark, professionals built the Titanic) _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
