I have installed FreeBSD 5.4 RELEASE and upgraded to -STABLE on a DELL
PE2850.
FreeBSD 5.4-STABLE #1: Wed May 25 23:43:12 BST 2005
CPU: Intel(R) Xeon(TM) CPU 3.20GHz (3192.22-MHz 686-class CPU)
real memory = 5100273664 (4864 MB)
avail memory = 4189892608 (3995 MB)
MPTable: <DELL PE 016D >
FreeBSD/SMP: Multiprocessor System Detected: 2 CPUs
cpu0 (BSP): APIC ID: 0
cpu1 (AP): APIC ID: 6
amr0: <LSILogic PERC 4e/Di> Firmware 516A, BIOS H418, 256MB RAM
I have disabled ACPI HTT and enabled PAE to make the whole system memory
available.
However the problem I have is the system can crash at any moment, and is not
load related. As the crash info below is when the machine was in an 100%
idle state.
##### Crash Info ##########
login:
kernel trap 12 with interrupts disabled
Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0x24
fault code = supervisor read, page not present
instruction pointer = 0x8:0xc031f64b
stack pointer = 0x10:0xeab21c64
frame pointer = 0x10:0xeab21c78
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = resume, IOPL = 0
current process = 8 (pagedaemon)
trap number = 12
panic: page fault
cpuid = 0
boot() called on cpu#0
Uptime: 12h31m11s
Cannot dump. No dump device defined.
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
cpu_reset called on cpu#0
cpu_reset: Stopping other CPUs
spin lock sched lock held by 0xc63f8c00 for > 5 seconds
#############################
I have tried to install other versions of FreeBSD.
4.11 Release (Doesn't see all available memory even with a kernel patch)
5.4 Release (Crashes at random times, but mainly under load, running squid)
Does anyone have similar problems or have found a work around?
Danny C
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
