At 03:59 PM 6/26/2008, prad wrote:
On Thu, 26 Jun 2008 20:53:00 +0200
Jos Chrispijn <[EMAIL PROTECTED]> wrote:
> Have a look at this URL:
> http://www.pugetsystems.com/articles.php?id=19
>
this was very interesting and thorough.
and thanks to everyone else who responded especially david and bill.
unfortunately, david, most of the links on that page you sent don't
work, but one of them did so that was helpful.
we have a chance to buy 18G scsi at $5 or 36G for $25.
what the seller isn't sure about is whether they will be compatible
with the particular server.
the server has a 36G seagate (ST336705LC) in it. the 18G are compaqs
(ultra 3 BD0186398C). do scsi's have any compatibility issues?
also, being older hardware, is there anything to be concerned about
regarding freebsd7. i know we've had problems getting 7 to boot and
install from the older cdroms (6.3 was easy), but the ide hds ran just
fine once 7 was installed.
--
In friendship,
prad
Yes those are cheap, and likely rebuilt or used drives.
First pick out your SCSI or RAID card, then be sure the drives you use
match that card. There are various cable and termination standards for
SCSI, you need to be sure you are using all the same ones on the card and
the drives.
If you are going to use these old drives I would opt to use NEW SATA 300
drives instead. These new drives will outperform those old SCSI models.
-Derek
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"