Sorry if this is obvious but I just did this myself with similar problems. Is your /boot a seperate partition? If so, bsd will not boot. It will happily install but will come back with a no kernel found error or similar. I believe this is because only the / partition is mounted at that point.
Hope this helps. Craig Russell --- [EMAIL PROTECTED] wrote: > I have installed FreeBSD 6.2 on an HP Proliant G5 > server with an E200i > Smart Controller installed. The installation was > flawless. > > When I reboot the server after the installation, the > boot loader screen is > displayed. I press F1 and the system beeps and > comes back to the boot > loader prompt. > > What should I be looking at? I am at a loss since I > usually end up with > leftover hardware and this time I acutally got to > purchase new hardware > just for this project. > > Any suggestions would be greatly appreciated. > > Thanks for your help. > > Jay > > _______________________________________________ > freebsd-questions@freebsd.org mailing list > http://lists.freebsd.org/mailman/listinfo/freebsd-questions > To unsubscribe, send any mail to > "[EMAIL PROTECTED]" > _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
