Both of those checked OK. Is it possible I have specified the C/H/S incorrectly during setup?
Thanks, Jay > At 10:49 AM 4/26/2007, [EMAIL PROTECTED] wrote: >>I have installed FreeBSD 6.2 on an HP Proliant G5 server with an E200i >>Smart Controller installed. The installation was flawless. >> >>When I reboot the server after the installation, the boot loader screen >> is >>displayed. I press F1 and the system beeps and comes back to the boot >>loader prompt. >> >>What should I be looking at? I am at a loss since I usually end up with >>leftover hardware and this time I acutally got to purchase new hardware >>just for this project. >> >>Any suggestions would be greatly appreciated. >> >>Thanks for your help. > > Check your BIOS that you are ALLOWING the boot sector to be written. > > If that is OK, try disabling hyperthreading if that is turned on in your > BIOS. > > -Derek > > -- > This message has been scanned for viruses and > dangerous content by MailScanner, and is > believed to be clean. > MailScanner thanks transtec Computers for their support. > > _______________________________________________ [email protected] mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
