Derrick Ryalls wrote:
On 7/21/06, Rich Demanowski <[EMAIL PROTECTED]> wrote:
Derrick Ryalls wrote:
> On 7/21/06, Rich Demanowski <[EMAIL PROTECTED]> wrote:
>> I just dropped a SoundBlaster Live! card into my box, and have
followed
>> the directions in the handbook and the man pages.
>>
>> The following lines are in the compiled kernel:
>> device sound
>> device snd_emu10k1
>>
>> I don't get the pcm0 lines that section 7.2.2 in the manual talks
>> about. cat /dev/sndstat returns:
>> FreeBSD Audio Driver (newpcm)
>> Installed devices:
>> and nothing else.
>>
>> kldload snd_emu10k1 yields no output whatsoever. When followed by
cat
>> /dev/sndstat it produces the same outputs as above.
>>
>> kld_load snd_driver yields:
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0x20
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>> ppc0: parallel port not found.
>> sio1: configured irq 3 not in bitmap of probed irqs 0
>> sio1: port may not be enabled
>>
>> I recompiled with the sound and emu10k1 drivers commented out, and
the
>> kldload and cat /dev/sndstat commands still yield the same.
>>
>> I need to get sound enabled on this box, so I can do some online
>> training provided through streaming video. Please, please, please
tell
>> me I don't have to break down and install wankers on this thing ...
>>
>
> I would try this:
>
> kldload snd_driver
>
> then cat /dev/sndstat to see if perhaps a different driver is needed.
I tried that. That's what got me all the ppc0 and sio1 errors.
Sorry, missed that. Record heat around here. My only other
suggestion would involve a different sound card or possibly try a live
O/S disk to see if the hardware is good.
Where/how do I obtain one of those? All I have are the install discs 1
and 2 that I downloaded the iso images for, and all I can get from those
is an "emergency holographic shell" that can't even find the ls command,
let alone kldload ...
_______________________________________________
freebsd-questions@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-questions
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
