Mine's a white unit, no onboard ethernet. The only bus powered device I'm running right now is the aue ethernet, which I can easily dump for testing. The HD is self powered. I'd love a microdrive, but figured I had this 60GB IDE drive floating loose, and the enclosure/adapter was only $35... might as well try right? : ) Previously I've been netbooting but getting ticked with random locks under load, under both Net and FreeBSD. No warning, no errors just stops dead in it's tracks. Figured getting 'local' storage might stabilize things.
Have you gotten the backlight control code ported over to FreeBSD for these rigs? I'd love to have a screensaver module that just shut the LCD down. Joshua Coombs ----- Original Message ----- From: "J. Seth Henry" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Cc: <[EMAIL PROTECTED]> Sent: Friday, January 03, 2003 10:25 AM Subject: RE: 5.0RC2 on an iPaq IA1 > Don't rule out hardware problems. I have been working with 4.7R on an > IA-1. The power supplies in there aren't the greatest, and I've had > problems with wireless keyboards loading the units down to where they had > problems booting. > > I would suggest you get a self-powered USB hub, and make all your > connections through it (or try one of those keychain NAND drives). I > managed to get everything, including the wireless keyboard transciever, to > work just fine that way. > > That said, I've had the most success with booting my IA-1 from a > microdrive. I did have to boost the CF Vcc to 5V by lifting and jumpering > the middle two pins to an unused serial connector (CN10), but that done, > the system is remarkably stable. > > BTW - is your IA-1 a white or blue unit? I'm still trying to figure out > how to get FBSD to recognize the external MII PHY on the clipper ethernet > port. > > Good luck, > Seth Henry > > >>> > iPaq# usbdevs -v > Controller /dev/usb0: > addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), > VIA(0x0000), rev 1.00 > port 1 powered > port 2 addr 2: full speed, self powered, config 2, USB 2.0 Storage > Adaptor(0xb001), DMI(0x0c0b), rev 11.10 > Controller /dev/usb1: > addr 1: full speed, self powered, config 1, UHCI root hub(0x0000), > VIA(0x0000), rev 1.00 > port 1 powered > port 2 addr 2: full speed, power 156 mA, config 1, LINKSYS USB > Adapter(0x400b), LINKSYS Inc.(0x066b), rev 1.01 > > Suggestions on how to debug or reduce the errors? The drive has good > media > (hooked direct to IDE it tests clean using Quantum's diag util) and the > system will boot fine with a warm reboot of the comp itself, so I'm > guessing > the problem is driver related and not a fault with the HW. > > Joshua Coombs > [EMAIL PROTECTED] > > > > To Unsubscribe: send mail to [EMAIL PROTECTED] with "unsubscribe freebsd-questions" in the body of the message
