On Sunday 25 December 2005 20:51, you wrote: > Yuan Jue wrote: > > On Sunday 25 December 2005 19:53, you wrote: > > yes. they are not on the same LAN. > > but when I use my local NIC to connect the internet, everything is fine. > > the following is how my local NIC works: > > > > [EMAIL PROTECTED] ifconfig > > bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500 > > options=1a<TXCSUM,VLAN_MTU,VLAN_HWTAGGING> > > inet 166.111.208.204 netmask 0xfffffe00 broadcast 166.111.209.255 > > ether 00:0d:9d:90:e0:68 > > media: Ethernet autoselect (100baseTX <full-duplex>) > > status: active > > lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384 > > inet 127.0.0.1 netmask 0xff000000 > > [EMAIL PROTECTED] ping 166.111.8.28 > > PING 166.111.8.28 (166.111.8.28): 56 data bytes > > 64 bytes from 166.111.8.28: icmp_seq=0 ttl=251 time=0.525 ms > > > > why does this work? it has the same netmask and broadcast address > > as the wireless NIC. Any more explanations? > > OK, now, if you have two nic's configured for the same lan things get > wierd. Try > > # ifconfig bge0 down > > And, check that default route is set correctly.
thank you very much. it does work now. :) you know, back to FreeBSD 5.4, things like this never happened. so I even never think about close the local NIC down to get the wireless one works. Maybe this is the FreeBSD 6.0's improvement on wireless access, right? > > I think the default route binds not only to an ip but also to the > interface that connects to that network, so maybe you have configured > both bge0 and ath0 and default route set to go out bge0. Now, when you > disconnect bge0 and try to ping, your ping is not sent on ath0 as you > might think but on bge0. thanks for your explanations. It is very appreciated. > > To check this kind of problems, use snort to sniff what's actually > leaving your interface. > > Cheers, Erik -- Best Regards. Yuan Jue _______________________________________________ freebsd-questions@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-questions To unsubscribe, send any mail to "[EMAIL PROTECTED]"
