On Sat, Dec 26, 2009 at 09:42:48AM -0500, Steven Friedrich wrote: > On Friday 25 December 2009 11:42:43 pm Weongyo Jeong wrote: > > On Fri, Dec 25, 2009 at 11:44:12AM -0800, Sam Leffler wrote: > > > Steven Friedrich wrote: > > > >On Thursday 24 December 2009 05:09:42 pm Weongyo Jeong wrote: > > > >>OK. It looks weird idProduct didn't be decreased 1 after loading the > > > >>firmware. > > > >> > > > >>And what I'd like to see is the *full* result of the following steps: > > > >> > > > >> 1. plugs in your USB device. > > > >> 2. run commands as follows: > > > >> > > > >> # kldload if_uath > > > >> # dmesg | tail > > > >> # uathload -v -d /dev/ugen4.3 > > > >> # dmesg | tail > > > >> > > > >>In a theory, after loading the firmware normally the device which at > > > >> the moment idProduct is 0x4251 is detached and reseted then it should > > > >> be reattached with idProduct(0x4250). > > > >> > > > >>regards, > > > >>Weongyo Jeong > > > > > > > >Opps, I'm sorry, the reply I just sent ws wrong because once you've used > > > >uathload, you have to unplugplug the device before you can run it again. > > > >So here it is: > > > >Load firmware ar5523.bin (builtin) to /dev/ugen4.3 > > > >send block 0: 147368 bytes remaining > > > > > > > > : data... > > > > : wait for ack...flags=0x14 total=149416 > > > > > > <...snip...> > > > > > > The device should detach and be re-enumerated w/ a different device id > > > that the driver attaches to. Hard to say why it does not. > > > > > > uathload should be automatically run by devd but it appears the devd > > > rules file I did got lost (don't see it in the tree). > > > > I agree with sam@ that it's hard to understand why it's not detached > > after downloading the firmware. > > > > Yesterday I ordered `Netgear Wireless USB Adapter WG111T' which probably > > is same one with you so I could reproduce your problem and debug it. > > Thanks for your effort. I appreciate it.
Could you please test with attached patch? Today the device I ordered is delivered and I tried to test with it. One thing, it looks weird, I noticed is that after uploading the firmware, idProduct is increased not decreased. After patching, you should rebuild the module. regards, Weongyo Jeong _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"