Steven Friedrich wrote:
On Thursday 24 December 2009 05:09:42 pm Weongyo Jeong wrote:
OK. It looks weird idProduct didn't be decreased 1 after loading the
firmware.
And what I'd like to see is the *full* result of the following steps:
1. plugs in your USB device.
2. run commands as follows:
# kldload if_uath
# dmesg | tail
# uathload -v -d /dev/ugen4.3
# dmesg | tail
In a theory, after loading the firmware normally the device which at the
moment idProduct is 0x4251 is detached and reseted then it should be
reattached with idProduct(0x4250).
regards,
Weongyo Jeong
Opps, I'm sorry, the reply I just sent ws wrong because once you've used
uathload, you have to unplugplug the device before you can run it again.
So here it is:
Load firmware ar5523.bin (builtin) to /dev/ugen4.3
send block 0: 147368 bytes remaining
: data...
: wait for ack...flags=0x14 total=149416
<...snip...>
The device should detach and be re-enumerated w/ a different device id
that the driver attaches to. Hard to say why it does not.
uathload should be automatically run by devd but it appears the devd
rules file I did got lost (don't see it in the tree).
Sam
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "freebsd-net-unsubscr...@freebsd.org"