The following reply was made to PR kern/112654; it has been noted by GNATS.

From: [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED], "Andy Farkas" <[EMAIL PROTECTED]>
Subject: Re: kern/112654: [pcn] Kernel panic upon if_pcn module load on a 
Netfinity 5000
Date: Tue, 22 Jan 2008 19:23:17 +0100

 New test was carried out today using Marius' patch (and not using Andy's patch 
at the same time).
 The new kernel re-introduces the original problem, loading the if_pcn driver 
while the RJ45 cable is connected results in a kernel panic and the system 
reboots. While the cable is disconnected the if_pcn module loads fine, after 
which the cable can be plugged back and the card can be used as expected.
 
 ### Here is what shows up upon "kldload if_pcn" while the cable is unplugged 
###
 pcn0: <AMD PCnet/PCI 10/100BaseTX> port 0x2180-0x219f mem 0xfebff800-0xfebff81f
 irq 17 at device 9.0 on pci0
 pcn0: Chip ID 2624 (Am79C972)
 miibus5: <MII bus> on pcn0
 nsphyter0: <DP83843 10/100 media interface> on miibus5
 nsphyter0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
 ukphy0: <Generic IEEE 802.3u media interface> on miibus5
 ukphy0:  10baseT, 10baseT-FDX, auto
 pcn0: Ethernet address: 00:06:29:50:d9:9e
 
 ### At that point ifconfig says: ###
 [EMAIL PROTECTED] ~# ifconfig pcn0
 pcn0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
         ether 00:06:29:50:d9:9e
         media: Ethernet autoselect (none)
         status: no carrier
 ### Then I connect the RJ45 cable coming from the switch and: ###
 [EMAIL PROTECTED] ~# ifconfig pcn0
 pcn0: flags=8802<BROADCAST,SIMPLEX,MULTICAST> mtu 1500
         ether 00:06:29:50:d9:9e
         media: Ethernet autoselect (100baseTX <full-duplex>)
         status: active
 [EMAIL PROTECTED] ~#
 
 
 ### Now here is what "kldload if_pcn" does while the cable is connected: ###
 pcn0: <AMD PCnet/PCI 10/100BaseTX> port 0x2180-0x219f mem 0xfebff800-0xfebff81f
 irq 17 at device 9.0 on pci0
 pcn0: Chip ID 2624 (Am79C972)
 miibus5: <MII bus> on pcn0
 nsphyter0: <DP83843 10/100 media interface> on miibus5
 nsphyter0: no media present
 ifmedia_set: no match for 0x0/0xfffffff
 panic: ifmedia_set
 
 Regards,
 Keve
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"

Reply via email to