On Tue, Nov 06, 2007 at 04:38:19PM +0200, Alexander Shikoff wrote: > On Tue, Nov 06, 2007 at 04:19:14PM +0200, Alexander Shikoff wrote: > > Hello, > > > > I have box with 7.0-BETA2 installed (csup-ed and built today). > > There is a problem with on-board Gigabit Realtek card: > > > > re0: <RealTek 8168/8111B PCIe Gigabit Ethernet> port 0xc000-0xc0ff mem > > 0xf2000000-0xf2000fff irq 17 at device 0.3 > > re0: Using 2 MSI messages > > miibus0: <MII bus> on re0 > > re0: Ethernet address: 00:1a:4d:52:4e:b1 > > re0: [FILTER] > > re0: [FILTER] > > > > It is connected to another FreeBSD 6.2 box with cross-over UTP-cable. > > At the other side there is 'active' status. But re0 at my side > > shows always 'no carrier'. I tried to change UTP-patch-cord but > > without success. > > > > # pciconf -lv > > [...] > > [EMAIL PROTECTED]:3:0:0: class=0x020000 card=0xe0001458 chip=0x816810ec > > rev=0x01 hdr=0x00 > > vendor = 'Realtek Semiconductor' > > device = 'RTL8168/8111 PCI-E Gigabit Ethernet NIC' > > class = network > > subclass = ethernet > > [...] > > Further investigation... It seems that re(4) driver does not > support auto-negotiation correctly. If I manually set media to 100baseTX and > bring up interface with 'ifconfig re0 up' then it works. >
Would you show me more information for link partner(i.e. FreeBSD 6.2 box)? -- Regards, Pyun YongHyeon _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"
