What man/handbook pages/sections should I look at to get a clue. I'm
so far from having one, I don't even know the direction...
Thanks,
-Jim Stapleton
On 6/26/07, Artyom Viklenko <[EMAIL PROTECTED]> wrote:
Jim Stapleton wrote:
> That partially worked. I could only ping 192.168.1.1 on my local setup
> (router).
>
> I used
> $ mpd pptp0
>
> However, I couldn't access the work DNS either. The latter output of
> MPD looked like:
> ==========
> pptp0] IPCP: rec'd Configure Ack #4 link 0 (Ack-Sent)
> IPADDR <IP-ADDR-A>
> [pptp0] IPCP: state change Ack-Sent --> Opened
> [pptp0] IPCP: LayerUp
> <IP-ADDR-A> -> <IP-ADDR-B>
> [pptp0] IFACE: Up event
> [pptp0] setting interface ng0 MTU to 1396 bytes
> [pptp0] exec: /sbin/ifconfig ng0 <IP-ADDR-A> <IP-ADDR-B> netmask
> 0xffffffff -link0
> [pptp0] exec: /sbin/route add <IP-ADDR-A> -iface lo0
> [pptp0] exec: /sbin/route add 0.0.0.0 <IP-ADDR-B>
> [pptp0] exec: command returned 256
> ==========
>
>
> I could ping <IP-ADDR-A> and <IP-ADDR-B> after running mpd, but I
> could not ping them before running it, or after shutting it down. Both
> are valid IP addresses on my works internal network.
>
> Aside from my nve0 and l0 devices, which look normal, ifconfig
> displays the following:
>
> ==========
> ng0: flags=88d1<UP,POINTOPOINT,RUNNING,NOARP,SIMPLEX,MULTICAST> mtu 1396
> inet <IP-ADDR-A> --> <IP-ADDR-B> netmask 0xffffffff
> ==========
>
> I could not ping the DNS servers.
>
> Any suggestions?
I think you need static route to your VPN server.
After setting up tullel your default route changes.
This can lead to incorrect routing.
--
Sincerely yours,
Artyom Viklenko.
-------------------------------------------------------
[EMAIL PROTECTED] | http://www.aws-net.org.ua/~artem
FreeBSD: The Power to Serve - http://www.freebsd.org
_______________________________________________
freebsd-net@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-net
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
