On Sun, 18 Sep 2005 14:15:51 -0400, in sentex.lists.freebsd.net you wrote: >Im having an issue with my new linksys eg1032 nic and the onboard intel >82547EI on my new server. ill go over both problems individually and >include my dmesg below that. > >now the EM problem. > >when i am running a very high network load (streaming video, dumping >ALOT of data across the network, etc) the network card disconnects (i >loose pings and all my transfers drop) and 15-20 seconds later it pops >up on the console with "em0: Link is up 1000 Mbps Full Duplex" and then >it starts working again. again im at a dead wall and really want my >network to work properly so i can do what i need to do. >
Not sure about the sk issue, but there have been some changes to the em driver since 5.4. If you can, I would try moving to 6.0R when it comes out. Also, what is the em nic plugged into ? Does the port have any logging facilities to see what might be going on from the switch's perspective ? ---Mike -------------------------------------------------------- Mike Tancsa, Sentex communications http://www.sentex.net Providing Internet Access since 1994 [EMAIL PROTECTED], (http://www.tancsa.com) _______________________________________________ freebsd-net@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-net To unsubscribe, send any mail to "[EMAIL PROTECTED]"