Jan Mikkelsen wrote:
On 15/01/2012, at 6:00 PM, Roman Kurakin wrote:
Hi,
Jan Mikkelsen wrote:
Hi,
I'm looking to upgrade a system running frame relay over a Sangoma A101 card
and WANPIPE.
Sangoma do not support FreeBSD anymore, so I'm looking for alternatives.
What hardware does ng_frame_relay support now that ar(4) and sr(4) are not in
FreeBSD 9?
Specifically, will ng_frame_relay work with a Digium TE121 and ports/dahdi-kmod?
Any suggestions welcome, G.703, X.21 or V.35 interfaces OK.
Check also www. cronyx. ru for ce(4) and cp(4). As far as I know, an old
digium adapters were using
software framer for HDLC, but I don'k know the current state. If they didn't
provide hardware framer
now, I suggest to check for any other adapter.
Thanks. Just had a look at their site; they support up to 6.x, there is a red
note saying 7.x is not supported. I suspect that would also apply to 8.x and
9.x ...
I know, I quit the company and support was stopped at that point. But
code in the base tree,
and should work.
For now going with a standalone router. Might have a look at the Digium card
more closely if I have a different application for it ...
Then take a look at www. nsg. ru they have nice linux based boxes.
Though, I didn't play with them by my self.
Best regards,
rik
rik
Regards,
Jan.
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscr...@freebsd.org"
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscr...@freebsd.org"
