On 29 Jan 2011, at 23:24, "Bjoern A. Zeeb" <bzeeb-li...@lists.zabbadoz.net>
wrote:
> On Sat, 29 Jan 2011, Damien Fleuriot wrote:
>
>> Hello lists,
>>
>>
>> I'm trying to get FreeBSD 8.0 or 8.1 to run on a Dell poweredge r210 server.
>>
>> It ships with a SATA/SAS h200 RAID controller.
>>
>>
>> Sadly, the MFI driver doesn't seem to register for this card...
>>
>>
>> Find below the pciconf -lcvb
>>
>> --
>> none6@pci0:1:0:0: class=0x010700 card=0x1f1d1028 chip=0x00721000
>> rev=0x02 hdr=0x00
>> vendor = 'LSI Logic (Was: Symbios Logic, NCR)'
>> class = mass storage
>> subclass = SAS
>> bar [10] = type I/O Port, range 32, base 0xfc00, size 256, enabled
>> bar [14] = type Memory, range 64, base 0xdf2b0000, size 65536, enabled
>> bar [1c] = type Memory, range 64, base 0xdf2c0000, size 262144, enabled
>> cap 01[50] = powerspec 3 supports D0 D1 D2 D3 current D0
>> cap 10[68] = PCI-Express 2 endpoint max data 256(4096) link x8(x8)
>> cap 03[d0] = VPD
>> cap 05[a8] = MSI supports 1 message, 64 bit
>> cap 11[c0] = MSI-X supports 15 messages in map 0x14
>> --
>>
>>
>> I have added the following to /usr/src/sys/dev/mfi/mfi_pci.c at line 119:
>> --
>> {0x1000, 0x0072, 0x1028, 0x1f1e, MFI_FLAGS_GEN2, "Dell PERC H200
>> Integrated"},
>> --
>
> It's 1f1d not 1f1e. I hope it was only a paste problem into email?
>
Nope no copy paste problem, I shall try again tomorrow with 1f1d then.
I found this line on the nginx site where the issue was being discussed.
Will post back my results asap.
>
>>
_______________________________________________
freebsd-hackers@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-hackers
To unsubscribe, send any mail to "freebsd-hackers-unsubscr...@freebsd.org"
