On 2013/12/18 23:48, Alexey Dokuchaev wrote:
On Sun, Oct 06, 2013 at 10:24:09AM -0700, Alfred Perlstein wrote:
I got one of these (if_urtwn) and it works enough to download about a meg
or so before the watchdog kicks in and I have to ifconfig down/up it to
get it to respond again.
I even have a patch pending to add the usb identifier for this.
Same here; someone at $work bought couple of these teeny dongles. I've
applied small id patch (attached), and tried to use it (it reportedly
works flawlessly under Linux using this [*] driver). I could load the
module, but MAC address was clearly bogus (00:00:30:34:43:30); yet I've
created wlan0 just to find out that there is no list scan results, and
wpa_supplicant(8) gives me this in an endless loop (GENERIC kernel, so
I presume all wlan-related stuff should be in place):
Successfully initialized wpa_supplicant
ioctl[SIOCS80211, op=103, val=0, arg_len=128]: Device not configured
wlan0: Failed to initiate AP scan
This is on relatively fresh 11-CURRENT as of Oct 18th, i386. Any clues?
It would be nice to get more of these little guys to work, esp. there is
working Linux driver available for reference.
Your usb wlan dongles use RTL8188EU chip which is currently not
supported by any of drivers.
./danfe
[*] https://github.com/liwei/rpi-rtl8188eu
Kevin
_______________________________________________
freebsd-current@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscr...@freebsd.org"
