Hi all,
I have been having HARD -current hangs recently and they don't seem to be
going away by cvsupping. I've been having two complete lockups (i.e. no
response from X, network or serial terminal; no crashdump no whatsoever),
which occured both times after approximately 10 days of uptime. The two
hangs occurred with differently dated -currents. It seems to be
repeatable...
My configuration is an Abit BP6 with two 400 Mhz celerons (NO
overclocking), and an ATA66 disk.
FreeBSD relativity.student.utwente.nl 4.0-CURRENT FreeBSD 4.0-CURRENT #0:
Mon Feb 7 22:46:30 CET 2000
[EMAIL PROTECTED]:/usr/src/sys/compile/RELATIVITY5 i386
I have no idea what is causing the lockups, does anyone have similar
experiences (so far I only read about lockups that occurred more
often than once every 10 days or so).
I can provide access to the machine and its logfiles, though I doubt that
they are very useful (don't contain any obvious hints to what's causing
these lockups).
One last note: I didn't have these lockups before January 2000.
Please, can someone shed some light on this?
Regards,
Dave Boers.
--
Dave Boers < djb @ relativity . student . utwente . nl >
Don't let your schooling interfere with your education. (Mark Twain)
----> DMESG <----
Copyright (c) 1992-2000 The FreeBSD Project.
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
FreeBSD 4.0-CURRENT #0: Mon Feb 7 22:46:30 CET 2000
[EMAIL PROTECTED]:/usr/src/sys/compile/RELATIVITY5
Timecounter "i8254" frequency 1193182 Hz
CPU: Pentium II/Pentium II Xeon/Celeron (400.91-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x665 Stepping = 5
Features=0x183fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR>
real memory = 134217728 (131072K bytes)
avail memory = 127033344 (124056K bytes)
Programming 24 pins in IOAPIC #0
IOAPIC #0 intpin 2 -> irq 0
FreeBSD/SMP: Multiprocessor motherboard
cpu0 (BSP): apic id: 0, version: 0x00040011, at 0xfee00000
cpu1 (AP): apic id: 1, version: 0x00040011, at 0xfee00000
io0 (APIC): apic id: 2, version: 0x00170011, at 0xfec00000
Preloaded elf kernel "kernel" at 0xc02fe000.
Preloaded elf module "vesa.ko" at 0xc02fe09c.
VESA: v3.0, 7936k memory, flags:0x1, mode table:0xc02fb102 (1000022)
VESA: NVidia
Pentium Pro MTRR support enabled
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Intel 82443BX (440 BX) host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
pcib1: <Intel 82443BX (440 BX) PCI-PCI (AGP) bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
vga-pci0: <NVidia Riva TNT graphics accelerator> mem
0xe6000000-0xe6ffffff,0xe4000000-0xe4ffffff irq 16 at device 0.0 on pci1
isab0: <Intel 82371AB PCI to ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
ata-pci0: <Intel PIIX4 ATA-33 controller> port 0xf000-0xf00f at device 7.1 on pci0
pci0: Intel 82371AB/EB (PIIX4) USB controller (vendor=0x8086, dev=0x7112) at 7.2
intpm0: <Intel 82371AB Power management controller> port 0x5000-0x500f irq 9 at device
7.3 on pci0
intpm0: I/O mapped 5000
intpm0: intr IRQ 9 enabled revision 0
smbus0: <System Management Bus> on intsmb0
smb0: <SMBus general purpose I/O> on smbus0
intpm0: PM I/O mapped 4000
ed0: <NE2000 PCI Ethernet (RealTek 8029)> port 0xa400-0xa41f irq 19 at device 9.0 on
pci0
ed0: address /* deleted */, type NE2000 (16 bit)
ahc0: <Adaptec 2940A Ultra SCSI adapter> port 0xa800-0xa8ff mem 0xeb000000-0xeb000fff
irq 18 at device 11.0 on pci0
ahc0: aic7860 Single Channel A, SCSI Id=7, 3/255 SCBs
pci0: unknown card (vendor=0x10b7, dev=0x9055) at 13.0 irq 17
ata-pci1: <HighPoint HPT366 ATA-66 controller> port
0xb800-0xb8ff,0xb400-0xb403,0xb000-0xb007 irq 18 at device 19.0 on pci0
ata2 at 0xb000 irq 11 on ata-pci1
ata-pci2: <HighPoint HPT366 ATA-66 controller> port
0xc400-0xc4ff,0xc000-0xc003,0xbc00-0xbc07 irq 18 at device 19.1 on pci0
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: FIFO enabled, 8 bytes threshold
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <keyboard controller (i8042)> at port 0x60-0x6f on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: model Generic PS/2 mouse, device ID 0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> on isa0
sc0: VGA <16 virtual consoles, flags=0x200>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
sio2: not probed (disabled)
sio3: not probed (disabled)
ppc0: <Parallel port> at port 0x378-0x37f irq 7 flags 0x40 on isa0
ppc0: Generic chipset (NIBBLE-only) in COMPATIBLE mode
ppbus0: IEEE1284 device found /NIBBLE
Probing for PnP devices on ppbus0:
ppbus0: <Hewlett-Packard HP LaserJet 5L/0101.02> HP ENHANCED PCL5,PJL
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
sbc0: <Creative SB16/SB32> at port 0x220-0x22f,0x330-0x331,0x388-0x38b irq 5 drq 1,5
on isa0
sbc0: setting card to irq 5, drq 1, 5
pcm0: <SB DSP 4.13> on sbc0
unknown0: <Generic ESDI/IDE/ATA controller> at port 0x168-0x16f,0x36e-0x36f irq 10 on
isa0
unknown1: <StereoEnhance> at port 0x100 on isa0
unknown2: <Game> at port 0x200-0x207 on isa0
unknown3: <PNP0000> at port 0x20-0x21,0xa0-0xa1 irq 2 on isa0
unknown4: <PNP0200> at port 0-0xf,0x81-0x83,0x87,0x89-0x8b,0x8f-0x91,0xc0-0xdf drq 4
on isa0
unknown5: <PNP0100> at port 0x40-0x43 irq 0 on isa0
unknown6: <PNP0b00> at port 0x70-0x71 irq 8 on isa0
unknown: <PNP0303> can't assign resources
unknown: <PNP0800> can't assign resources
unknown7: <PNP0c04> at port 0xf0-0xff irq 13 on isa0
unknown8: <PNP0c01> at iomem
0-0x9ffff,0xfffe0000-0xffffffff,0xfec00000-0xfec0ffff,0xfee00000-0xfee0ffff,0x100000-0x7ffffff
on isa0
unknown9: <PNP0c02> at iomem
0xf0000-0xf3fff,0xf4000-0xf7fff,0xf8000-0xfffff,0xce800-0xcffff on isa0
unknown: <PNP0a03> can't assign resources
unknown: <PNP0f13> can't assign resources
unknown10: <PNP0c02> at port 0x208-0x20f on isa0
unknown: <PNP0501> can't assign resources
unknown: <PNP0700> can't assign resources
unknown: <PNP0400> can't assign resources
unknown: <PNP0501> can't assign resources
APIC_IO: Testing 8254 interrupt delivery
APIC_IO: routing 8254 via IOAPIC #0 intpin 2
IP packet filtering initialized, divert enabled, rule-based forwarding enabled,
logging limited to 100 packets/entry by default
Waiting 10 seconds for SCSI devices to settle
SMP: AP CPU #1 Launched!
ad0: 17206MB <WDC AC418000D> [34960/16/63] at ata2-master using UDMA66
Mounting root from ufs:/dev/ad0s1a
cd1 at ahc0 bus 0 target 2 lun 0
cd1: <TEAC CD-ROM CD-516S 1.0D> Removable CD-ROM SCSI-2 device
cd1: 10.000MB/s transfers (10.000MHz, offset 8)
cd1: cd present [309750 x 2048 byte records]
cd0 at ahc0 bus 0 target 1 lun 0
cd0: <PLEXTOR CD-R PX-R412C 1.05> Removable CD-ROM SCSI-2 device
cd0: 10.000MB/s transfers (10.000MHz, offset 8)
cd0: Attempt to query device size failed: NOT READY, Medium not present
WARNING: / was not properly dismounted
pci0: Intel 82371AB/EB (PIIX4) USB controller (vendor=0x8086, dev=0x7112) at 7.2
xl0: <3Com 3c905B-TX Fast Etherlink XL> port 0xac00-0xac7f mem 0xeb001000-0xeb00107f
irq 17 at device 13.0 on pci0
xl0: Ethernet address: /* deleted */
miibus0: <MII bus> on xl0
xlphy0: <3Com internal media interface> on miibus0
xlphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
To Unsubscribe: send mail to [EMAIL PROTECTED]
with "unsubscribe freebsd-current" in the body of the message
