On 7/31/2012 12:44 AM, Alex Harui wrote:
On 7/30/12 7:57 PM, "Justin Mclean" <jus...@classsoftware.com> wrote:
Hi,
Flash Builder is giving me the eternally helpful "unknown error" message when
trying to compile a project.
Sounds bad - possible running out of memory? Try ant from the command line and
see what happens.
If you are building from trunk, I don't think using Flash Builder is
supported. After you run ant, then you can think about using one of the
repackaging techniques then you can use Flash Builder.
I was trying to understand what the "repackaging techniques" actually
do; and therefore was trying to go through the steps manually, without
using one of the tools. I'm sorry if that wasn't clear; I was under the
impression I had stated earlier in the thread I was responding to.
The same steps I went through w/ RC3 were not working when using the
trunk, which was a surprise to me. I'll check out the link Om provided
later to see if I can figure out what I did wrong.
--
Jeffry Houser
Technical Entrepreneur
203-379-0773
--
http://www.flextras.com?c=104
UI Flex Components: Tested! Supported! Ready!
--
http://www.theflexshow.com
http://www.jeffryhouser.com
http://www.asktheflexpert.com
--
Part of the DotComIt Brain Trust
