Hi all;
I have about half the code written & to implement the results, so the
question is: which of the G10 codes is the equ of a touch off for the
named axis's?
I am probing the outside edge of a disc so the error will be measured by
subtracting the x left value from the x right value found by g38.2 and
the correction being that result /2. Ditto for y in and y out, drive
machine to found values and issue the g10 equ to 0.000 touchoffs Repeat
till the error is essentially zero. Correct? Or is my thinking duff?
What I want to do then is power the probe to do EDM and make an odd
shaped center hole in a fabric cutter disc that is about 5mm in diameter
now, out to 16mm in diameter. disc is .3mm thick. Using deionized water
as dielectric, works great in previous work, rc arcing at 42 volts.
Thanks all.
Cheers, Gene Heskett, CET.
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author, 1940)
If we desire respect for the law, we must first make the law respectable.
- Louis D. Brandeis
Don't poison our oceans, interdict drugs at the src.
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
