I have been thinking about using an old touch probe as a tool setter to measure both z and diameter offset. Anyone had any luck with that so far? I think it would be fancy if I could measure the diameter at the same time as the z offset. My cheap sk40 tool holders have some run out, and using tool compensation to get better tolerances would be fun. /Peter
Den tis 21 maj 2024 kl 16:59 skrev andy pugh <[email protected]>: > On Tue, 21 May 2024 at 15:25, Todd Zuercher <[email protected]> wrote: > > > While your design is very simple and robust, it’s lack of adjustability > > seems like it would be a bit of a problem. > > > > I have added adjustability for use as an in-spindle probe to the one I > use. Just a flange with an M2 thread and adjusting screws. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is designed > for the especial use of mechanical geniuses, daredevils and lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1912 > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
