wire edm , use ground clip on the shaft so no current thru bearings
if wedm is available, its an easy job tomp On 10/18/21 9:34 AM, Ralph Stirling wrote:
I just got a great deal on three 750w brushless servos and drives to upgrade my cnc mill. They have the same face dimensions, but the shafts are 5mm longer than the old brush servos. There was no clearance between the motor shaft and ball screw inside the coupler, so I need shorten the 32mm long 19mm diam shafts by 5mm. Can this be done without damage to the motor from heat or vibration? I don't want to have to pull the ball screws. Thanks, -- Ralph _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
