> On 27 Dec 2020, at 21:10, Andrew <[email protected]> wrote: > > > Can STMBL pass the encoder value to LinuxCNC? Yes, and very conveniently as a Mesa smart-serial device. In fact the STMBL low-voltage board probably has a role as an encoder interface board, ignoring the power driver board. _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
- Re: [Emc-users] Relatively cheap harmonic actuator John Dammeyer
- Re: [Emc-users] Relatively cheap harmonic actuator Andrew
- Re: [Emc-users] Relatively cheap harmonic actuator andy pugh
- Re: [Emc-users] Relatively cheap harmonic actuato... Jérémie Tarot
- Re: [Emc-users] Relatively cheap harmonic actuato... Andrew
- Re: [Emc-users] Relatively cheap harmonic act... Andy Pugh
- Re: [Emc-users] Relatively cheap harmonic... Andrew
- Re: [Emc-users] Relatively cheap har... Andy Pugh
- Re: [Emc-users] Relatively cheap... Andrew
- Re: [Emc-users] Relatively cheap... Andy Pugh
- Re: [Emc-users] Relatively cheap... Jérémie Tarot
- Re: [Emc-users] Relatively cheap... andy pugh
- Re: [Emc-users] Relatively cheap... Jérémie Tarot
- Re: [Emc-users] Relatively cheap harmonic actuator Jérémie Tarot
