On Sat, Sep 5, 2020 at 12:11 PM Mark <[email protected]> wrote: > Folks seem to clamor quite a > bit how all this is going to die out and we need to change this, that > and every other thing to enable all these other platforms. Yet, none of > them seem to want to grab the software and change it to their wants or > needs. It always seems the developers must change their wants. Tormach > proved that wasn't necessary. > > Mark > > It's not too many folks, but the same ones make a lot of noise. It seems to me that there are some nice gcode senders out there that could do what the noisy people want with less work than adapting linuxcnc to be a gcode sender with an as-of-yet undefined distributed control interface on the other end of a non-real time network interface.
Granted, that's a whole lot of work. Eric Keller Boalsburg, Pennsylvania _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
