On Fri, Sep 4, 2020 at 9:50 AM Mark Wendt <[email protected]> wrote:
> On Fri, Sep 4, 2020 at 12:41 PM Chris Albertson <[email protected] > > > wrote > > ...So, to make LinuxCNC nearly universal, hide it inside a product that > is > > slick and easy to install and use. No one should have to look at HAL > files > > or know it runs on Linux. They can learn, but if learning is required it > > will always remain a niche product. > > > > Great stuff! So, when are you going to get started on this project? > I wrote that to show why it will never happen. But also to make a point that there does exist a pattern in the way complex niche products become mainstream. Usually, another layer is built around it. PCs were kind of rare until Windows covered over the DOS command line. > > Mark > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Chris Albertson Redondo Beach, California _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
