You can never go thicker layer or narrower line width than the diameter of the
nozzle. Somewhere over 100% to 150% width is where you want the width. Under
50% of the thickness makes it harder to extrude.
https://www.reddit.com/r/3Dprinting/comments/5zxj1z/should_line_width_always_nozzle_size/
On Saturday, June 6, 2020, 12:14:12 PM MDT, Gene Heskett
<[email protected]> wrote:
On Saturday 06 June 2020 14:01:52 Chris Albertson wrote:
> DO I read this as using 0.3mm line width? If the nozzle has a 0.4mm
> hole you must set the line width to 0.4.
I don't recall setting that, it was an autoselected choice that I think
came with the super quality setting. If I make it bigger, how much
bigger?
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
