>> >>> If you are controlling the speed of your spindle with LinuxCNC instead of >>> just ON/OFF/DIR, how are you doing this? >>> >>> Step/Dir? >>> >>> 0V-10V PWM?
I’m using PWM with a direct signal and enable. My drive accepts 0-10V, so I created a little board that converts the PWN to a 0-10V analog signal and isolates all the signals. N. Christopher Perry >>> >>> ModBus? >>> If ModBus RS232 or RS485? >>> >>> Some other way? >>> >>> Thanks >>> John >>> >>> >>> "ELS! Nothing else works as well for your Lathe" >>> Automation Artisans Inc. >>> www dot autoartisans dot com >>> >>> >>> _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >>> >> >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users > > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
