On 03/23/2019 01:34 PM, Moses McKnight wrote:
On 3/23/19 1:16 PM, Gene Heskett wrote:
... Gotta learn geda and friends I guess.
If you're trying EDA software, I found Kicad to be far
easier to learn and use than Eagle or Geda - and it's
quite powerful these days.
I still run an expensive licensed version of Protel99 SE.
It has a few quirks, but is quite solid and the schematic
vs. PCB checks are totally perfect. Any weakness there can
cost you serious $$$.
I inherited the CRAMPS board from Charles Steinkuehler,
which he designed in Kicad. While Kicad is not quite up to
the level of Protel99, it definitely is getting close. And,
there has been a major rev update since I tried it, so it is
likely even better.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
