Hi One thing that I noticed day before problem with encoder. I am using m52 to stop feed with 5 vdc that converted to frequency etc, When I stop feed, machine has changes in few thausands . X and y axis moved in few thausands but z axis was more quite . And next day z axis motor stop working. That may indicate something
On Sun, Mar 3, 2019, 7:01 PM a k <[email protected]> wrote: > Hi > Stuart > Phone is there, maybe even same number but owner different. > I did call few years ago and another company did purchased original > servodinamics. > > Motors drive not exactly same. Today owner say that original servodinamic > was very small business etc > > > > > On Sun, Mar 3, 2019, 5:38 PM Stuart Stevenson <[email protected]> wrote: > >> Aram, >> I just searched for aerodynamics. I called the telephone number on the web >> page. Servo dynamics' phone system answered and told me if I knew my >> party's extension I could dial it at any time. I hung up at that time. It >> looks as if the report of their demise is a little premature. >> Thanks >> Stuart >> >> On Sun, Mar 3, 2019, 5:26 PM a k <[email protected]> wrote: >> >> > Hi >> > I just found that encoder on my servomotor stop working. >> > I turn shaft and number does not changing. >> > Enverything was good yesterday . >> > Today not. >> > It is servodynamic motor. Company not exist any more. >> > I did not run it whole a lot. >> > How I can check that it is encoder motor and not a drive? >> > >> > Also, if I find similar size nema 34 , do I need to return again? >> > >> > Thanks >> > Aram >> > >> > >> > >> > >> > >> > >> > >> > >> > >> > On Mon, Jan 28, 2019, 1:59 PM Thaddeus Waldner <[email protected]> >> wrote: >> > >> > > Hi, >> > > >> > > I have a small machine with spindle motor driven by a Toshiba VFS-11 >> vfd. >> > > I currently have a forward and reverse signal controlling the drive >> but I >> > > need to be able to control the speed. From what I’ve seen, this drive >> > > connects digitally via the modus protocol, and someone actually wrote >> a >> > > driver for this drive for LinuxCNC. Can someone direct me to a list of >> > > instructions on how to get it set up that way? >> > > >> > > Thanks, >> > > Thaddeus Waldner >> > > >> > > _______________________________________________ >> > > Emc-users mailing list >> > > [email protected] >> > > https://lists.sourceforge.net/lists/listinfo/emc-users >> > > >> > >> > _______________________________________________ >> > Emc-users mailing list >> > [email protected] >> > https://lists.sourceforge.net/lists/listinfo/emc-users >> > >> >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
