Running PathPilot in lathe mode applies offsets for X, Y and Z. > -----Original Message----- > From: andy pugh [mailto:[email protected]] > Sent: Wednesday, February 13, 2019 9:08 AM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] G43 question > > On Wed, 13 Feb 2019 at 13:18, Ken Strauss <[email protected]> wrote: > > > > Yes, Tool 1 has a new entry for X after running the posted gcode (unset > > offsets are not present). Note that this was tested using Tormach's > > PathPilot > > You would _definitely_ expect X offsets to work on a lathe. Especially > as the Tormach lathe uses a gang toolholder. > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > - George Fitch, Atlanta Constitution Newspaper, 1916 > > > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users
_______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
