On 4 May 2018 at 03:29, jeremy youngs <[email protected]> wrote:

>> I get this message no matter what I tell pnc it is. 5i25,7i43 etc . All
>> give me the same you haven forgot to assign pwm/ step to x,y,z, axis.

Have you actually assigned a stepper or pwm to each axis?

In this page:
http://linuxcnc.org/docs/devel/html/config/pncconf.html#_mesa_i_o_setup

What do you have? It could be on any connector but you do need to have
something trying to output the drive command for each axis.

-- 
atp
"A motorcycle is a bicycle with a pandemonium attachment and is
designed for the especial use of mechanical geniuses, daredevils and
lunatics."
— George Fitch, Atlanta Constitution Newspaper, 1916

------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to