Negative, it's what I got when I invoked the kernel log command, those
would be what has been stored since last update 3 months ago. I will clear
it and do kernel log later this evening, right now I got 2 guys wrenching
in my shop so I'm trying to get them out.

You should also know I have had real time issues , I replaced Mobo 3months
ago due to eating ram, the capacitor kit was more than a reconditioned
Mobo. I have had no issues since but real time error , task 1 has
persisted. Peculiar, jitter is pretty good , and I have gotten 300 ipm on
these stepper . 9*42 knee mill.
I haven't pursued the real time issue as I have not had functional internet
here. I am very near that at this time. I can however, now get you latency
test results and dmesg. I have a Dell 510? 610 ? Laptop with parallel, the
lack of high speed prevents a burn of lcnc and install at the moment, I may
well do that in the next day or 2. I will likely run the latency and clean
up this message later tonight.
Thank you
------------------------------------------------------------------------------
Check out the vibrant tech community on one of the world's most
engaging tech sites, Slashdot.org! http://sdm.link/slashdot
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to