Hi Christian, There are no bare boards without parts on them. The board is mostly surface mount parts. The through hole parts are not installed. The kit without the micro-stepper parts will cost you $200 Cdn. Soldering time is about 3 to 5 hours. Best to use 22g rosin core solder to get good bonding with the leads of the switches etc.
John > -----Original Message----- > From: jeremy youngs [mailto:[email protected]] > Sent: April-20-18 1:14 PM > To: Enhanced Machine Controller (EMC) > Subject: Re: [Emc-users] Mesa choices > > 7i90 and cable should be here tomorrow, timing belts and pulleys on the > way > too. I'm going to see if I can get a pinout on these renco encoders , I > figure once the mess card is hooked up I can count the pulse in one > rotation and go from there. Pretty busy the next few days so it will be mid > week before I really get to focus energy on this. Exciting times, sure more > questions to come. I'm going to get a dead tree copy if the lcnc manual and > the integrator manual done up in the next week or so. TTYL > ---------------------------------------------------------------------------- -- > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
