Or get it water jet cut. Most of the time it is accurate enough for tap holes down to about #10. I can water jet you the adaptor at school for next to nothing, but can't guarantee a lead time. This time of year all the projects are in full swing and since I am staff and not a student anymore I'd be pushed to the very end of the wait list.
Kurt Jacobson 505-303-1933 Sent from Mobile On Thu, Mar 15, 2018, 12:07 PM andy pugh <[email protected]> wrote: > On 15 March 2018 at 15:44, Todd Zuercher <[email protected]> wrote: > > > I'm in Ohio, and the part I need is a mild steel adapter ring for the > nose of a spindle. It is 6.5 inches (165mm) diameter, and 10mm thick, > center hole is 96mm, and has two hole circles of 8 holes each. The outer > circle is on a 155.5mm circle and is tapped for 6mm screws, the inner > circle is offset to the outer one on a 115mm circle and is drilled and > counter sunk for 6mm flat head screws. > > I think I would get a laser-cut ring made, then true it up on a lathe > and then mark-out and drill by hand. > > (though you could probably spot the hole locations on one of your routers) > > > -- > atp > "A motorcycle is a bicycle with a pandemonium attachment and is > designed for the especial use of mechanical geniuses, daredevils and > lunatics." > — George Fitch, Atlanta Constitution Newspaper, 1916 > > > ------------------------------------------------------------------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, Slashdot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
