good progress , i cant come up with any omissions , at least at this stage
On 29 December 2016 at 19:01, TJoseph Powderly <[email protected]> wrote: > planning 3 tabs > 'tech' you select edm parameters from a flatfile database OR rool your own > on/off/current/polarity/ignition voltage > 'cut' you control live cut generator on/off, offtime, target voltage, > gain for edm servo, peck cutting parms, fill(flood) & flushing parms > and you monitor AvgVoltage AvgCurrent Stability Arcing ... ooops it > 2am, cutting it short > 'strategy' orbiting > > tomp tjtr33 > > > ------------------------------------------------------------ > ------------------ > Check out the vibrant tech community on one of the world's most > engaging tech sites, SlashDot.org! http://sdm.link/slashdot > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > -- The information contained in this message is confidential and is intended for the addressee only. If you have received this message in error or there are any problems please notify the originator immediately. The unauthorised use, disclosure, copying or alteration of this message is strictly forbidden. This mail and any attachments have been scanned for viruses prior to leaving the RcTechnix network. RcTechnix will not be liable for direct, special, indirect or consequential damages arising from alteration of the contents of this message by a third party or as a result of any virus being passed on. RcTechnix reserves the right to monitor and record e-mail messages being sent to and from this address for the purposes of investigating or detecting any unauthorised use of its system and ensuring effective operation. (c) RcTechnix ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, SlashDot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
