Greetings everybody; This is about the r-pi, running raspian. So it uspace linuxcnc in the late, as in just updated from the buildbot an hour back
With only a very small change to the .ini file, I have it looking like a lathe in the axis display. 1st question: If I comment out all the y stuff, does that change the joints = 3 to a 2? 2nd question: Does this make axis Z's joint 2 into a 1? I ask because the last time tried to clean up the .ini and first .hal files, I wound up with a configuration that didn't run, and gave no reason why. 3rd: Question. In the axis .ini and .hal files, are they supposed to be fully 'joints merged' ? Thank you. Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ Developer Access Program for Intel Xeon Phi Processors Access to Intel Xeon Phi processor-based developer platforms. With one year of Intel Parallel Studio XE. Training and support from Colfax. Order your platform today. http://sdm.link/xeonphi _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
