If you can get gerber files out gED, you might try FlatCAM. I have been using for over a year now with excellent results. You can set it up to run multiple isolation passed very easily.
Ray --J. Ray Mitchell Jr. [email protected] (818)324-7573 The dogmas of the quiet past, are inadequate to the stormy present. The occasion is piled high with difficulty, and we must rise with the occasion. As our case is new, so we must think anew and act anew. We must disenthrall ourselves, and then we shall save our country.*Abraham Lincoln <http://www.quotationspage.com/quotes/Abraham_Lincoln/>*, *Annual message to Congress, December 1, 1862* *16th president of US (1809 - 1865)* On Sat, Jan 16, 2016 at 2:25 PM, Gene Heskett <[email protected]> wrote: > Greetings all; > > I was able to make a usable circuit in gEDA, but I am not terribly > impressed with the gcode that pcb exports. Only one pass for the trace > isolation, so I an having to dig a good 5 thou into the substrate to get > rid of 99% of the shorts. The rest I'll clean up by hand, BTDT before. > > Regardless, I have a slab of double sided on the mill, carving the bottom > only, 6 up, so I'll have boards enough I can sell 3 of them if anyone is > interested. Say $5 each empty, and perhaps a $20 populated and tested. > When I have completed the drill file, I'll clear the copper on the top > side from any lead hole as its intended to be single sided, but I don't > hardly have some more of that. > > 3 terminals, ground, a pulse from a BoB pin, and an output (sinks to > ground) to a relay coil or an SSR. Response times on a 5 volt circuit > s/b under .25 seconds. But I don't know if it will work on a 3.3 volt > swing, doubtfull in fact. All my BoB's output 5 volts, rail to rail. > > Interested, PM me. > > And thanks. > > Cheers, Gene Heskett > -- > "There are four boxes to be used in defense of liberty: > soap, ballot, jury, and ammo. Please use in that order." > -Ed Howdershelt (Author) > Genes Web page <http://geneslinuxbox.net:6309/gene> > > > ------------------------------------------------------------------------------ > Site24x7 APM Insight: Get Deep Visibility into Application Performance > APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month > Monitor end-to-end web transactions and take corrective actions now > Troubleshoot faster and improve end-user experience. Signup Now! > http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Site24x7 APM Insight: Get Deep Visibility into Application Performance APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month Monitor end-to-end web transactions and take corrective actions now Troubleshoot faster and improve end-user experience. Signup Now! http://pubads.g.doubleclick.net/gampad/clk?id=267308311&iu=/4140 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
