I'm having problems getting started with 5i20 7i33 7i77. I began this
project a couple of years ago and was delayed for various reasons. I have a
mid 80's Mill with brushed servos that run. Nothing has been done to the
wiring of it yet. I want to get it running with Linux CNC. I am going to
ask some questions that I'm sure will show my ignorance. I have Ubuntu
10.04 with Linux CNC installed on a P-4 that shows good latency. The 5i20
is in the PCI bus, the 7i33 and 7i37 are plugged in I believe the correct
way. I have used the wizzard to configure for 5i20 and 3 axis servo to the
best of my abilitiy. I believe that the card is recognized (lights up red,
then goes out when I start Linux CNC). Should i get pin-out info by
typing "dmesg > hm2.txt" in terminal? I believe I it showed up once
yesterday but haven't been able to get it today. "dmesg" does show
information, but no pin out.I could use a pointer in the correct
direction. I've been reading the manual but I am stuck.
------------------------------------------------------------------------------
BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT
Develop your own process in accordance with the BPMN 2 standard
Learn Process modeling best practices with Bonita BPM through live exercises
http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_
source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
