------ Original Message ------ From: "andy pugh" <[email protected]> To: "Marius Liebenberg" <[email protected]>; "Enhanced Machine Controller (EMC)" <[email protected]> Sent: 2015-04-14 14:18:42 Subject: Re: [Emc-users] 7i80 Setup ( Was PNCConf setup)
>On 14 April 2015 at 13:10, Marius Liebenberg <[email protected]> >wrote: >> The 7i80 only has digital output and inputs. No device driver stuff >>at >> all just three 50 pin ports. > >Ah, yes, sorry. I was confusing it with the 7i76E I think. > >Which firmware is it using? > It depends on what daughter cards are connected and if you use a sserial expansion card. As far as I know the standard firmware that it comes with is good enough for most configurations but I had to load something else due to the fact that I fitted a 7i44 and my firmware was old. >-- >atp >If you can't fix it, you don't own it. >http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
