I have made good head way since yesterday, communicating thru the new NIC card, on modified IP thru eeprom. I have my config up and running, can see all my hal signals I created, except the pwmgen's, I have tried numerous different verbage, different entries in the loadrt line in my hal, different things in the HOSTMOT2 section of my INI, and no luck. I keep getting that they are not recognized in the printout when it faults when trying to start from the command line.
I have read thru the HOSTMOT2 manual section on this, and should be no different than the three other machines I have running on 5i23's with pwmgen's. Any idea's or a direction to head in for different documentation on setting them up? I wouldn't think that would have changed going to a debian build using the hm2_eth driver. -- Thanks Rick Lair Superior Roll & Turning LLC 399 East Center Street Petersburg MI, 49270 PH: 734-279-1831 FAX: 734-279-1166 www.superiorroll.com ------------------------------------------------------------------------------ BPM Camp - Free Virtual Workshop May 6th at 10am PDT/1PM EDT Develop your own process in accordance with the BPMN 2 standard Learn Process modeling best practices with Bonita BPM through live exercises http://www.bonitasoft.com/be-part-of-it/events/bpm-camp-virtual- event?utm_ source=Sourceforge_BPM_Camp_5_6_15&utm_medium=email&utm_campaign=VA_SF _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
