On Thursday 27 February 2014 19:57:14 jeremy youngs did opine: > !!!!gene stated > FWIW, I have the mixed rubber washer/fender washer style dampers on my > motors except for the one on my A/B/C table. I should make another for > it, but I find its speed is adequate without it. They are a huge help > at soaking up the mid-band resonances that can cause a stall at 1/3rd > of full speed. Take them off the mill and I have to reduce the > maxvel's in the .INI to about 1/3 or 1/4. That is how important they > are! > > so i have to ask any pics or a link gene ? this sounds great !!! > > > > jeremy youngs
Sheesh, doesn't anyone read sigs anymore? ;p) See the emc link on my web page at the link in the sig. That FWIW, is this machine. Some of the pix spreads are a bit dated, I need to do some house cleaning come warmer weather & take some fresh pix, maybe even make a movie of thread cutting on the lathe with no change gears, the coupling is all in LinuxCNC. Cheers, Gene -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> NOTICE: Will pay 100 USD for an HP-4815A defective but complete probe assembly. ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
