I think (and Sam can probably confirm) that he was using two separate computers in both cases.
On Tue, Feb 25, 2014, at 10:45 AM, Steve Stallings wrote: > Also wonder if there is any concern if the > LinuxCNC looking at LinuxCNC is taking > synchronized readings thus avoiding one source > of jitter, while LinuxCNC looking at Mach3 is > two different computers with independent timing. > > Steve Stallings John Kasunich [email protected] ------------------------------------------------------------------------------ Flow-based real-time traffic analytics software. Cisco certified tool. Monitor traffic, SLAs, QoS, Medianet, WAAS etc. with NetFlow Analyzer Customize your own dashboards, set traffic alerts and generate reports. Network behavioral analysis & security monitoring. All-in-one tool. http://pubads.g.doubleclick.net/gampad/clk?id=126839071&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
