See if the address that is used when the parport driver is loaded in the HAL file is what you expected it to be. You can also post you HAL file here so we can have look at that for you.
On 2014-02-05 10:10, Matthieu Patou wrote: > Hello All, > > I have an atom desktop with a partport at 0x378 and a 7i43 + 7i42 hooked > to it and it's working well with LinuxCNC 2.5.3. > On a thinkpad laptop I have a PCMCIA parport card at 0x3bc and when I > try to run Axis, after configuring this laptop for the same card, I got > errors about missing card at address 0x378 even though I configured it > to 0x3BC. > > Did I miss something or is the port specified during PNCConf ignored ? > > Matthieu. > > ------------------------------------------------------------------------------ > Managing the Performance of Cloud-Based Applications > Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. > Read the Whitepaper. > http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 ------------------------------------------------------------------------------ Managing the Performance of Cloud-Based Applications Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. Read the Whitepaper. http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
