Also, PNCCONF might not have loaded the parport driver that you should use.
On 2014-02-05 10:10, Matthieu Patou wrote: > Hello All, > > I have an atom desktop with a partport at 0x378 and a 7i43 + 7i42 hooked > to it and it's working well with LinuxCNC 2.5.3. > On a thinkpad laptop I have a PCMCIA parport card at 0x3bc and when I > try to run Axis, after configuring this laptop for the same card, I got > errors about missing card at address 0x378 even though I configured it > to 0x3BC. > > Did I miss something or is the port specified during PNCConf ignored ? > > Matthieu. > > ------------------------------------------------------------------------------ > Managing the Performance of Cloud-Based Applications > Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. > Read the Whitepaper. > http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Regards /Groete Marius D. Liebenberg +27 82 698 3251 +27 12 743 6064 ------------------------------------------------------------------------------ Managing the Performance of Cloud-Based Applications Take advantage of what the Cloud has to offer - Avoid Common Pitfalls. Read the Whitepaper. http://pubads.g.doubleclick.net/gampad/clk?id=121051231&iu=/4140/ostg.clktrk _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
