you also might want to set the coordinate system to the value of the tool's offset from the tool offset table..
--- On Mon, 5/7/12, Chris Radek <[email protected]> wrote: > From: Chris Radek <[email protected]> > Subject: Re: [Emc-users] Behavior of Touch-Off Dialog (and Tool Table Editor?) > To: "Enhanced Machine Controller (EMC)" <[email protected]> > Date: Monday, May 7, 2012, 8:18 PM > On Mon, May 07, 2012 at 09:39:27PM > -0500, Kim Kirwan wrote: > > I have continued this subject in its own thread, > because I also > > think that Andy's proposal is a good one, for the > reason that > > it would make it very easy to make minor adjustments by > > > using the built-in math functions: > > > > > (user starts touch-off dialog) > > 12.3456 (appears in > touch-off dialog) > > 12.3456 - 0.001 (user makes minor adjustment w/ > math) > > 12.3446 (after user > clicks "accept" or whatever) > > > (user clicks "done" and dialog closes) > > Am I understanding your proposal correctly that 12.3456 is > the initial > entry in the touch-off dialog because 12.3456 is the current > value of > the selected axis? > > If that's what you're proposing, then I sure can see how > that makes it > easier to do your differential math. > > However it also has the effect that the default action of > touch off is > to make no change (hit End, dialog appears, hit Enter, > coordinate does > not change). > > Currently, this default action, when no change is made, is > to set > the new axis value to zero. > > I must say that most often what I do with touch off is to > accept the > default zero value because I want to set the system origin > where the > tool is. I also frequently type +/- an edge finder or > probe tip > radius. > > In some cases, though, like for lathe X, I am always > touching off the > tool and very rarely would want the zero value there. > The value I > type will always be what my micrometer says (or that number > followed > by /2 if the gcode is in radius mode). But for lathe Z > I would > usually want the zero. > > I think current value and zero are the two initial values > that make > the most sense, but I don't know which one is useful MORE of > the time. > I suspect this is a matter of opinion and/or practice and > opinion > will be split. > > If someone sees a pattern that AXIS can use to get this > right, or a > clean, simple, discoverable and keyboardable way to make the > user > interface handle both cases, please speak up. > > Chris > > ------------------------------------------------------------------------------ > Live Security Virtual Conference > Exclusive live event will cover all the ways today's > security and > threat landscape has changed and how IT managers can > respond. Discussions > will include endpoint security, mobile security and the > latest in malware > threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > ------------------------------------------------------------------------------ Live Security Virtual Conference Exclusive live event will cover all the ways today's security and threat landscape has changed and how IT managers can respond. Discussions will include endpoint security, mobile security and the latest in malware threats. http://www.accelacomm.com/jaw/sfrnl04242012/114/50122263/ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
