Thanks for looking anyway. :-) My mistake. Dave
On 10/20/2011 2:17 PM, John Thornton wrote: > Ok, nevermind my last reply... > > John > > On 10/20/2011 11:33 AM, Dave wrote: > >>>>> John, is there an EMC2 demo configuration using the Mesa THC board >>>>> >> anywhere? I thought there used to be one in the Master?, but now I >> don't see it.<< >> >> Forget this request. It was right in front of me named "Plasma-5i20". >> >> Dave >> >> >> >> >> On 10/20/2011 11:49 AM, Dave wrote: >> >>> For those who are not familiar with the Hypertherm 1250, that plasma >>> cutter is a beast. >>> I used one on a production machine cutting large diameter coil springs. >>> It is very impressive. >>> >>> John, is there an EMC2 demo configuration using the Mesa THC board >>> anywhere? I thought there used to be one in the Master?, but now I >>> don't see it. >>> >>> Dave >>> >>> On 10/20/2011 7:31 AM, John Thornton wrote: >>> >>> >>>> On my Hypertherm 1250 plasma table cut charts I don't see any cut speeds >>>> higher than 500IPM. >>>> >>>> John >>>> >>>> On 10/19/2011 10:22 PM, Tom Easterday wrote: >>>> >>>> >>>> >>>>> We are mainly going to be using a plasma torch so may be cutting at >>>>> 200-1000 ipm (will be based on material and I haven't researched actual >>>>> rates - but should obviously). We would like rapids to be as fast as >>>>> reasonable, and this was part of the reason for selecting servos at all >>>>> and those motors specifically. With the current setup we will probably >>>>> have rapids at 2500 ipm. >>>>> >>>>> >>>>> >>>> >>> ------------------------------------------------------------------------------ >>> The demand for IT networking professionals continues to grow, and the >>> demand for specialized networking skills is growing even more rapidly. >>> Take a complimentary Learning@Ciosco Self-Assessment and learn >>> about Cisco certifications, training, and career opportunities. >>> http://p.sf.net/sfu/cisco-dev2dev >>> _______________________________________________ >>> Emc-users mailing list >>> [email protected] >>> https://lists.sourceforge.net/lists/listinfo/emc-users >>> >>> >>> >> ------------------------------------------------------------------------------ >> The demand for IT networking professionals continues to grow, and the >> demand for specialized networking skills is growing even more rapidly. >> Take a complimentary Learning@Ciosco Self-Assessment and learn >> about Cisco certifications, training, and career opportunities. >> http://p.sf.net/sfu/cisco-dev2dev >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > ------------------------------------------------------------------------------ > The demand for IT networking professionals continues to grow, and the > demand for specialized networking skills is growing even more rapidly. > Take a complimentary Learning@Cisco Self-Assessment and learn > about Cisco certifications, training, and career opportunities. > http://p.sf.net/sfu/cisco-dev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users > > ------------------------------------------------------------------------------ The demand for IT networking professionals continues to grow, and the demand for specialized networking skills is growing even more rapidly. Take a complimentary Learning@Cisco Self-Assessment and learn about Cisco certifications, training, and career opportunities. http://p.sf.net/sfu/cisco-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
