Ok, nevermind my last reply... John
On 10/20/2011 11:33 AM, Dave wrote: >>>> John, is there an EMC2 demo configuration using the Mesa THC board > anywhere? I thought there used to be one in the Master?, but now I > don't see it.<< > > Forget this request. It was right in front of me named "Plasma-5i20". > > Dave > > > > > On 10/20/2011 11:49 AM, Dave wrote: >> For those who are not familiar with the Hypertherm 1250, that plasma >> cutter is a beast. >> I used one on a production machine cutting large diameter coil springs. >> It is very impressive. >> >> John, is there an EMC2 demo configuration using the Mesa THC board >> anywhere? I thought there used to be one in the Master?, but now I >> don't see it. >> >> Dave >> >> On 10/20/2011 7:31 AM, John Thornton wrote: >> >>> On my Hypertherm 1250 plasma table cut charts I don't see any cut speeds >>> higher than 500IPM. >>> >>> John >>> >>> On 10/19/2011 10:22 PM, Tom Easterday wrote: >>> >>> >>>> We are mainly going to be using a plasma torch so may be cutting at >>>> 200-1000 ipm (will be based on material and I haven't researched actual >>>> rates - but should obviously). We would like rapids to be as fast as >>>> reasonable, and this was part of the reason for selecting servos at all >>>> and those motors specifically. With the current setup we will probably >>>> have rapids at 2500 ipm. >>>> >>>> >>> >> ------------------------------------------------------------------------------ >> The demand for IT networking professionals continues to grow, and the >> demand for specialized networking skills is growing even more rapidly. >> Take a complimentary Learning@Ciosco Self-Assessment and learn >> about Cisco certifications, training, and career opportunities. >> http://p.sf.net/sfu/cisco-dev2dev >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> >> > > ------------------------------------------------------------------------------ > The demand for IT networking professionals continues to grow, and the > demand for specialized networking skills is growing even more rapidly. > Take a complimentary Learning@Ciosco Self-Assessment and learn > about Cisco certifications, training, and career opportunities. > http://p.sf.net/sfu/cisco-dev2dev > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ The demand for IT networking professionals continues to grow, and the demand for specialized networking skills is growing even more rapidly. Take a complimentary Learning@Cisco Self-Assessment and learn about Cisco certifications, training, and career opportunities. http://p.sf.net/sfu/cisco-dev2dev _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
