I haven't tried that yet. But we will. Sent on the Sprint® Now Network from my BlackBerry®
-----Original Message----- From: Viesturs Lcis [email protected] Date: Mon, 28 Mar 2011 18:07:43 To: Enhanced Machine Controller (EMC)<[email protected]> Reply-To: "Enhanced Machine Controller \(EMC\)" <[email protected]> Subject: Re: [Emc-users] Programming issue > On Sun, Mar 27, 2011 at 2:19 PM, David Keeton <[email protected]> wrote: >> >> This is the line of the program in question........ >> >> G0G90G54T1 >> >> The next line is the M6 command. Is it ok to have G0 command without any axis word in one line with G90, G54 and toolchange commands? Did You try breaking up that compilation of commands in one commands per line and then see, which is causing problems? Viesturs ------------------------------------------------------------------------------ Enable your software for Intel(R) Active Management Technology to meet the growing manageability and security demands of your customers. Businesses are taking advantage of Intel(R) vPro (TM) technology - will your software be a part of the solution? Download the Intel(R) Manageability Checker today! http://p.sf.net/sfu/intel-dev2devmar _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ Enable your software for Intel(R) Active Management Technology to meet the growing manageability and security demands of your customers. Businesses are taking advantage of Intel(R) vPro (TM) technology - will your software be a part of the solution? Download the Intel(R) Manageability Checker today! http://p.sf.net/sfu/intel-dev2devmar _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
